A practical reference on reversed-phase HPLC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-08-01 and is reviewed periodically as new material appears.
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
从分子层面看，Semax 是线性七肽，没有二硫键、糖基或脂链修饰，N 端为游离氨基，C 端为游离羧基。分子含组氨酸与谷氨酸侧链，因此在水和甲醇等极性溶剂中溶解良好，在非极性溶剂中溶解有限。计算分子量约为 814 Da，与其质子化离子的质荷比吻合，可用于质谱确认。
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
| Property | Value | Notes |
|---|---|---|
| 分子式 | C37H51N9O10S | 游离碱形式 |
| 等电点 | 约 6.5 | 估算值，随缓冲体系变化 |
| 主要降解途径 | 水解与氧化 | 侧链氧化最为常见 |
| 溶液储存 | 2 至 8 摄氏度避光 | 避免反复冻融 |
| 常规分析手段 | 反相色谱与质谱联用 | 氨基酸分析辅助核对 |
Semax is supplied as a lyophilized powder that appears white to off-white. It dissolves readily in water, phosphate-buffered saline, and other aqueous media, which simplifies preparation of working solutions for laboratory use. The nasal products registered in Russia are dilute aqueous solutions, typically around 0.1 percent peptide by weight. Organic solvents are rarely necessary and can complicate handling. Because the peptide is hygroscopic, weighing should be performed quickly and with minimal exposure to ambient humidity.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Solid semax is typically supplied as a lyophilised powder that is hygroscopic and sensitive to moisture, light, and repeated temperature cycling. Long-term storage of the dry peptide is generally recommended at approximately -20 degrees Celsius, while shorter working periods may use refrigeration at 2 to 8 degrees Celsius. Vials should remain tightly closed and desiccated when brought to room temperature, because condensation can damage the material before it is weighed. Dividing a batch into aliquots is preferable to thawing one container repeatedly.
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
The board was reconstituted as Bromley Urban District Council in 1894 and the parish became Bromley Urban District. It formed part of the London Traffic Area from 1924 and the London Passenger Transport Area from 1933. In 1934, as part of a county review order, the borough was expanded by taking in 1,894 acres (766 hectares) from the disbanded Bromley Rural District; an area including parts of the parishes of Farnborough, Hayes, Keston and West Wickham. Bromley became part of the newly created Greater London in 1965, in the new London Borough of Bromley.
== Lifecycle == Bowfin spawn in the spring or early summer, typically between April and June, more commonly at night in abundantly vegetated, clear, shallow water in weed beds over sand bars and also under stumps, logs, and bushes. Optimum temperatures for nesting and spawning range between 16 and 19 °C (61 and 66 °F). The males construct circular nests in fibrous root mats, clearing away leaves and stems. Depending on the density of surrounding vegetation, a tunnel-like entrance may be at one side. The diameter of the nests commonly range between 39 and 91 cm (15 and 36 in), at a water depth of 61–92 cm (24–36 in). During spawning season, the fins and underside of male bowfin often change in color to a bright lime green. The courtship/spawning sequence lasts 1-3 hours and can repeat up to five times. Courtship begins when a female approaches the nest. The ritual consists of intermittent nose bites, nudges, and chasing behavior by the male until the female becomes receptive, when the pair lie side by side in the nest. She deposits her eggs, while he shakes his fins in a vibratory movement, and releases his milt for fertilization to occur. A male often has eggs from more than one female in his nest, and a single female often spawns in several nests. Females vacate the nest after spawning, leaving the male behind to protect the eggs during the 8-10 days of incubation. A nest may contain 2,000 to 5,000 eggs, possibly more. Fecundity is usually related to size of the fish, so the roe of a large gravid female may contain over 55,000 eggs.
All three genes localize to chromosome 19q.13.3 in the order of FPR1, FPR2, and FPR3 to form a cluster which also includes the gene for another G protein-coupled chemotactic factor receptor, the C5a receptor (also termed CD88), which binds and is activated by complement component 5a (C5a) and GPR77, a second C5a anaphylatoxin chemotactic receptor C5a2 (C5L2), a second C5a receptor of debated function which has the structure of a G protein coupled receptor but fails to couple to G proteins. These points are of interest because C5a is generated by the interaction of bacteria with blood plasma components to activate the complement cascade which then cleave C5a from Complement component 5. Thus, bacteria produce a family of oligopeptide chemotactic factors plus activate host complement pathways to generate C5a, which, like the formylated oligopeptides, is a neutrophil chemotactic factor that operates through receptors whose genes cluster with those for the three formyl peptide receptors. Furthermore, bacteria-induced complement activation also causes the formation of complement component 3a (C3a) by cleavage from complement component 3; C3a is a neutrophil chemotactic factor which operates through a G protein coupled chemotactic factor receptor, the C3a receptor, whose gene is located at chromosome 12p13; C3a also acts through C5L2.
The Agong at the time, Ahmad Shah of Pahang, agreed with the proposals in principle, but baulked when he realised that the proposal would deem Sultans to assent to laws passed by state assemblies. Supported by the Sultans, the Agong refused to assent to the constitutional amendments, which had passed both houses of Parliament with comfortable majorities. When the public became aware of the impasse, and the Sultans refused to compromise with the government, Mahathir took to the streets to demonstrate public support for his position in mass rallies. The press took the side of the government. A large minority of Malays, including conservative UMNO politicians, and an even larger proportion of the Chinese community supported the Sultans. After five months, the crisis was resolved, as Mahathir and the Sultans agreed to a compromise. The Agong retained the power to declare a state of emergency. However, if he refused to assent to a bill, the bill would return to Parliament, which could then override Agong's veto. In 1984, Mahathir was re-elected unopposed as UMNO president for a second term.
Sources: en.wikipedia.org
endogenous Originating or arising inside of an organism or cell; produced by the organism or cell itself, rather than sourced from the external environment; of or pertaining to native or internal factors or processes, to be distinguished from foreign or exogenous factors or processes.
Circularly polarised ultraviolet light has been shown to generate L-excesses in crystallising amino acids for experimental conditions mimicking alteration on asteroids, and this is thought to be the dominant extraterrestrial source of chiral symmetry breaking (i.e., the favouring of one enantiomer over another). It is notable that only excesses of the L-enantiomer have been observed in extraterrestrial amino acids, suggesting that the abiotic process responsible for enantiomeric enrichments may be the original source of the L-amino acid selectivity currently observed in terrestrial life.
lack of resistance to permanent deformation, resisting only relative rates of deformation in a dissipative, frictional manner, and the ability to flow (also described as the ability to take on the shape of the container). These properties are typically a function of their inability to support a shear stress in static equilibrium. By contrast, solids respond to shear either with a spring-like restoring force—meaning that deformations are reversible—or they require a certain initial stress before they deform (see plasticity). Solids respond with restoring forces to both shear stresses and to normal stresses, both compressive and tensile. By contrast, ideal fluids only respond with restoring forces to normal stresses, called pressure: fluids can be subjected both to compressive stress—corresponding to positive pressure—and to tensile stress, corresponding to negative pressure. Solids and liquids both have tensile strengths, which when exceeded in solids creates irreversible deformation and fracture, and in liquids cause the onset of cavitation. Both solids and liquids have free surfaces, which cost some amount of free energy to form. In the case of solids, the amount of free energy to form a given unit of surface area is called surface energy, whereas for liquids the same quantity is called surface tension. In response to surface tension, the ability of liquids to flow results in behaviour differing from that of solids, though at equilibrium both tend to minimise their surface energy: liquids tend to form rounded droplets, whereas pure solids tend to form crystals.
Sources: en.wikipedia.org
电喷雾或基质辅助激光解吸电离质谱是常用手段，测得的质子化离子质荷比可换算为分子量。结果与理论值落在合理误差内，才支持结构一致的判断。
甲硫氨酸侧链含硫醚，在氧气、光照或金属离子存在时容易被氧化。氧化产物极性略增，常在色谱图上表现为主峰之前的肩峰或前伸峰。
通常建议冷藏避光，并在较短时间内使用。不存在适用于所有配方的统一期限，具体取决于浓度、缓冲体系与容器材质。
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.