A practical reference on neuropeptide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-01-11 and is reviewed periodically as new material appears.
Semax is a synthetic heptapeptide developed in the Soviet Union during the 1980s by researchers at the Institute of Molecular Genetics in Moscow. It was designed as a truncated analog of adrenocorticotropic hormone, retaining only the fragment spanning residues four through ten. Investigators sought a peptide that would preserve the cognitive effects associated with ACTH while eliminating the hormonal stimulation of the adrenal cortex. The compound entered clinical use in Russia during the following decade.
Russian regulatory authorities approved the peptide for nasal administration, and it remains listed in the national pharmacopoeia under several trade names. Documented indications include acute ischemic stroke, transient ischemic attacks, traumatic brain injury, and certain ophthalmological and neurological conditions. Physicians also prescribe it for cognitive complaints in older patients, although the evidence base for that use is thinner. Outside Russia and a few neighboring states, the substance is not an approved medicine and is sold instead as a research chemical.
Later generations of the molecule include an N-acetylated form and an amidated form, both marketed online alongside the parent peptide. These variants differ in terminal chemistry and stability, and they are frequently discussed in the same breath even though they have not been compared in controlled trials. Supply outside formal healthcare systems comes largely from laboratories that synthesize peptides to order. Purity and identity of these materials vary widely, and no single body oversees the international trade.
多数实验室与市售的 Semax 以冻干粉形式提供。冻干粉通常建议保存在 -20 °C 或更低温度下，同时避免光照与反复升温。短期运输有时采用冷藏条件，但长期保存仍以冷冻为主。分包操作应尽量减少开盖次数，以降低吸湿和微生物污染的风险。开封后若未一次用完，建议在干燥环境中密封并尽快放回低温储存。
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic heptapeptide | Analog of an ACTH fragment |
| Amino acid length | Seven residues | Met-Glu-His-Phe-Pro-Gly-Pro |
| Origin | Moscow, 1980s | Institute of Molecular Genetics |
| Approved regions | Russia and some neighboring states | Not cleared in Western markets |
| Common trade names | Multiple national brands | Sold as a nasal formulation |
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. It was developed as a fragment analog of adrenocorticotropic hormone, modeled specifically on the ACTH(4-10) region. The first four residues reproduce that fragment, while a Pro-Gly-Pro tripeptide is appended at the C-terminus. Work on the compound originated in Russia, where it entered clinical use as an intranasal preparation. Its sequence places it among short regulatory peptides studied for effects on the central nervous system rather than on the adrenal axis.
The C-terminal Pro-Gly-Pro extension is not incidental. Proline-rich tails are known to resist several common peptidases, and the published literature attributes the longer half-life of Semax, relative to unmodified ACTH fragments, to this feature. The modification also removes the melanocyte-stimulating and corticosteroidogenic activity that characterizes longer ACTH-derived sequences. Because the molecule is small and hydrophilic, it is typically formulated as an aqueous solution for intranasal or parenteral delivery. Acetylation or amidation at the termini appears in closely related research peptides and shifts the mass by a fixed increment.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Dried timber is lighter, and the transportation and handling costs are reduced. Dried timber is stronger than green timber in most strength properties. Timbers for impregnation with preservatives have to be properly dried if proper penetration is to be accomplished, particularly in the case of oil-type preservatives. In the field of chemical modification of wood and wood products, the material should be dried to a certain moisture content for the appropriate reactions to occur. Dry wood generally works, machines, finishes and glues better than green timber (although there are exceptions; for instance, green wood is often easier to turn than dry wood). Paints and finishes last longer on dry timber. The electrical and thermal insulation properties of wood are improved by drying. Prompt drying of wood immediately after felling therefore significantly upgrades and adds value to raw timber. Drying enables substantial long-term economy by rationalizing the use of timber resources. The drying of wood is thus an area for research and development, which concern many researchers and timber companies around the world.
== Volume-temperature law == Regarding the volume-temperature relationship, Gay-Lussac attributed his findings to Jacques Charles because he used much of Charles's unpublished data from 1787 – hence, the law became known as Charles's law or the law of Charles and Gay-Lussac. Amontons's, Charles', and Boyle's law form the combined gas law. These three gas laws in combination with Avogadro's law can be generalized by the ideal gas law. Gay-Lussac used the formula acquired from ΔV/V = αΔT to define the rate of expansion α for gases. For air, he found a relative expansion ΔV/V = 37.50% and obtained a value of α = 37.50%/100 °C = 1/266.66 °C which indicated that the value of absolute zero was approximately 266.66 °C below 0 °C. The value of the rate of expansion α is approximately the same for all gases and this is also sometimes referred to as Gay-Lussac's law. See the introduction to this article, and Charles's law.
The different forms of MSH belong to a group called the melanocortins. This group includes ACTH, α-MSH, β-MSH, and γ-MSH; these peptides are all cleavage products of a large precursor peptide called proopiomelanocortin (POMC). α-MSH is the most important melanocortin for pigmentation. The different forms of MSH have the following amino acid sequences:
Sources: en.wikipedia.org
== As therapeutic targets == Modulation of PPI is challenging and is receiving increasing attention by the scientific community. Several properties of PPI such as allosteric sites and hotspots, have been incorporated into drug-design strategies. Nevertheless, very few PPIs are directly targeted by FDA-approved small-molecule PPI inhibitors, emphasizing a huge untapped opportunity for drug discovery. In 2014, Amit Jaiswal and others were able to develop 30 peptides to inhibit recruitment of telomerase towards telomeres by utilizing protein–protein interaction studies. Arkin and others were able to develop antibody fragment-based inhibitors to regulate specific protein-protein interactions. As the "modulation" of PPIs not only includes the inhibition, but also the stabilization of quaternary protein complexes, a paradigm introduced by the discovery of auxin-induced protein complex formation by Ning Zheng, molecules with this mechanism of action (so called molecular glues) are also extensively studied.
As early as 1941, integration of the many-body equations of motion was carried out with analog computers. Some undertook the labor-intensive work of modeling atomic motion by constructing physical models, e.g., using macroscopic spheres. The aim was to arrange them in such a way as to replicate the structure of a liquid and use this to examine its behavior. J.D. Bernal describes this process in 1962, writing:... I took a number of rubber balls and stuck them together with rods of a selection of different lengths ranging from 2.75 to 4 inches. I tried to do this in the first place as casually as possible, working in my own office, being interrupted every five minutes or so and not remembering what I had done before the interruption.Following the discovery of microscopic particles and the development of computers, interest expanded beyond the proving ground of gravitational systems to the statistical properties of matter. In an attempt to understand the origin of irreversibility, Enrico Fermi proposed in 1953, and published in 1955, the use of the early computer MANIAC I, also at Los Alamos National Laboratory, to solve the time evolution of the equations of motion for a many-body system subject to several choices of force laws. Today, this seminal work is known as the Fermi–Pasta–Ulam–Tsingou problem. The time evolution of the energy from the original work is shown in the figure to the right.
=== Li–Lu === Andreas Libavius (1555–1616), German doctor and alchemist who discovered how prepare hydrochloric acid, ammonium sulfate, etc. Carl Theodore Liebermann (1842–1914), German chemist, known for synthesis of alizarin Willard Libby (1908–1980), American chemist known for development of radiocarbon dating, 1960 Nobel Prize in Chemistry Justus von Liebig (1803–1873), German inventor and pioneer in agricultural and biological chemistry Karl Paul Link (1901–1978), American biochemist, discovered the anticoagulant warfarin John Wilfrid Linnett (1913–1975), British chemist at the Universities of Oxford and Cambridge, known for contributions to theoretical chemistry William Lipscomb (1919–2011), American chemist known for work in nuclear magnetic resonance, theoretical chemistry, boron chemistry, and biochemistry; 1976 Nobel Prize in Chemistry Joseph Lister, 1st Baron Lister (1827–1912), English surgeon known for recognising that putrefaction in wounds is caused by germs Arthur H. Livermore (1915–2009), American science educator and chemist who contributed to the synthesis of penicillin Mikhail Lomonosov (1711–1765), Russian scientist, anticipated the kinetic-molecular theory by 100 years H.
Sources: en.wikipedia.org
It originated at the Institute of Molecular Genetics in Moscow during the 1980s. The work was carried out by a Russian research group that specialized in peptide neuropharmacology.
It is registered as a medicine in Russia and has been used clinically there for decades. No regulatory agency in Western Europe or North America has approved it for any indication.
Semax corresponds to the four-to-ten fragment of adrenocorticotropic hormone. Because it omits the first three residues, it lacks the adrenal-stimulating action of the full hormone.
一般不建议常温长期保存。多数说明指向 -20 °C 冷冻避光。常温运输通常被视为短期可接受，但会加快降解风险。